Band Heaters-One Piece/Two Piece

Band Heaters-One Piece/Two Piece

Click this image to zoom it.

Move the mouse over the image to zoom

  • Band Heaters-One Piece/Two Piece
  • Band Heaters-One Piece/Two Piece


[ M ] Material: Cover of the Heater : SUS430
Mica for Insulation : Synthetic Mica
Nickel-chrome Wire : Nickel Chrome Ribbon Wire
Lead Wire : Nickel Copper Coated Wire
Lead Wire Heat Resistance Temperature: 180°C

[ A ] Accessory: Insulation Glass
(MBHS: 2 pcs. / MBHD: 4 pcs.)

Specifications

Part Number
MBHS40

Part Number 

  • Incomplete part number.
    Please use left hand selections to complete a part number.
Loading...
Part Number
MBHD100
MBHD120
MBHD150
MBHS40
MBHS50
Part NumberVolume DiscountDays to ShipRoHSRated Flow
(W)
Electric Power
(W)
Available 6 Day(s) or more 10150~250250
Available 6 Day(s) or more 10300~560300
Available 6 Day(s) or more 10300~560400
Available 6 Day(s) or more 10150~250150
Available 6 Day(s) or more 10150~250200

Loading...

  1. 1

More Information

■Features
- The band heater is a thin cylinder heater, coated with stainless steel plate, whose nickel-chrome wire is insulated with the heat-resistant mica board.
- One-piece type and two-piece type are available for different diameters of the heated object.
One-piece Type: Suitable for the cylinder of small diameter. 1 unit (2 pcs.) of terminals are included.
Two-piece Type: Suitable for the cylinders of relatively large diameter. 2 units (4 pcs.) of terminals are included.
- Max Operation Temperature: 300°C
■Usage
-Band heater can be used for cylinder shaped heated objects (work).
-Principal usages are: Heating of hot nozzles, pipes and cylinder shaped metal plates
■Precautions for Use
[ ! ] Do not let the heaters run in open air, for that will cause fires and heater element damages.
[ ! ] Apply electric power under the condition in which an object such as metal to be heated is attached to the heater.
[ ! ] Attach the object so that the heater comes into close contact with the surface to be heated.
A gap will cause premature breakage of wire.
[ ! ] After installation, energize it for several minutes, and tighten them once more after heated.
At that time, take care not to be burnt.
[ ! ] The heater is not waterproof. Avoid water splashes on the heaters.
[ ! ] Do not use over the rated voltage (V).
[ ! ] Use the temperature controller for safety.
[ ! ] Do not mount One-piece Type flat.
(Put the heated object through the heater.)

Example

 

Basic Information

Voltage(V) 200

Additional Products in this Category

Complementary Products

Customers Who Viewed This Item Also Viewed

Tech Support

Factory Automation
TEL:124- 468-8841 / FAX:124-468-8811
9:00am - 5:30pm (Monday -Saturday)