(!)NOTE : Windows 7 users won’t be able to use some latest features of eCatalog/WOS since Microsoft is ending support for Windows 7 on 14 Jan, 2020. Please upgrade your system for uninterrupted services.

Reamer Recommended Cutting Conditions

Carbide Reamer / Reamer with Carbide Bottom Blade Recommended Cutting Conditions Table

Model Number
SEC-HR / SEC-HSPR / SEC-HP-SPR / TSC-XHR / CHR / CHRL

Title image sample
Title image sample
The above are the cutting conditions for the SEC-HR (straight blade). The SEC-HSPR and SEC-HP-SPR (helical flute) can process with the above cutting conditions increased by 30 to 50%.
Title image sample For the High Accuracy Type CHR-HP and CHRL-HP, Neck Relief Type CHRZ and CHRLZ, and High Accuracy Neck Relief Type CHRZ-HP and CHRLZ-HP, refer to the above conditions and process similarly.
Title image sample Be sure to use cutting oil.  In particular, during deep hole drilling, continuously supply sufficient amounts of cutting oil to the machined section.
Title image sample The above cutting conditions are recommended values. So optimize these within the range ±30% for use.
Title image sample Use a machine and chuck that have rigidity and high accuracy.

Model Number
SEC-RMSC / SEC-RMSRC / SEC-RMSCC / SEC-ECHR /
SEC-HP-RMS□□/ SEC-RMS□□L / SEC-RMS□□Z / SEC-ECSPHR

Title image sample
Title image sample
For the High Accuracy Type SEC-HP-RMS□□, Long Type SEC-RMS□□L, and Neck Relief Type SEC-RMS□□Z, refer to the conditions above for the standard type and process similarly.
Title image sample The above are cutting conditions for the SEC-ECHR (straight blade). The SEC-ECSPHR (helical flute) can process with the above conditions increased by 30 to 50%.

Carbide Boring End Mill Cutting Conditions Table

Model Number
TAC-BREM3R

Title image sample
* Cautions in Setting Cutting Conditions

1. Cutting speed is determined based on standard cutting conditions. However, when the runout accuracy of the holder (shrink-fit holders are recommended) and machining center spindle are high, cut at slightly higher conditions.
2. Stable cutting is possible when the finishing allowance is set within 1/3 or higher of the C chamfer section of the boring end mill tip.

High-Speed Reamer Recommended Cutting Conditions

Title image sample

Finishing Allowance in Reaming (Reamer Allowance)

Title image sample