Dedicated Cutters Recommended Cutting Conditions

Model Number
C-PGSRC


Model Number
C-PGC / C-PGTC

Model Number
C-SMGC / C-SMBGC / C-SMEGC

● Use a machine and chuck that have rigidity and high accuracy.
● Select cutting oil suitable for the work material.
● Use F-RGC at feed rates of 50% of the criteria listed below.

Model Number
H-RGC / F-RGC

Model Number
PGSRC / PM-PGSRC


Model Number
PGC / PM-PGC


Model Number
PGTC / PM-PGTC

Model Number
SMGC / PM-SMGC / SMBGC / PM-SMBGC / SMEGC / PM-SMEGC

● The following table shows machining conditions when applying gradient to side surfaces.
● With the C-BTEMH, halve the feed rates in the table below when machining.

Model Number
BTEMH / C-BTEMH

● This table was made based on an Ad (cut depth) of 0.5 to 1.0 D.
● Use a machine and chuck that have rigidity and high accuracy.
● Select cutting oil suitable for the work material.
● If the rotational speed does not increase with your machine, lower the feed rate and rotational speed at the same ratio.
● For fraction sizes of flute diameter D, refer to the larger of the number values.

Model Number
SVKEM / SVKWC

Model Number
TSC / LTSC

● This table was made based on an Ad (cut depth) of 0.5 D.
● Use a machine and chuck that have rigidity and high accuracy.
● Select cutting oil suitable for the work material.
● Cutting conditions also change when the blade portion is shape-processed. So adjust the optimum cutting conditions by referring to the following.

Model Number
SEMH

● This table was made based on an Rd (cut width) of 0.1 D and an Ad (cut depth) of 1.5 D.
● Use a machine and chuck that have rigidity and high accuracy.
● Select cutting oil suitable for the work material.
● Cutting conditions also change when the blade portion is shape-processed. So adjust the optimum cutting conditions by referring to the table below.

Model Number
SEMH

Model Number
CTB

● This table was made based on the machining conditions in the figure above.
● Use a machine and chuck that have rigidity and high accuracy.
● Select cutting oil suitable for the work material.
● If the rotational speed does not increase with your machine, lower the table feed rate and rotational speed at the same ratio.
● TS and XAL coating allows both the feed speed and rotational speed to be increased up to x 150 % in the following conditions.

Model Number
F-RTREM / RTREM

● Use a machine and chuck that have rigidity and high accuracy.
● Select cutting oil suitable for the work material.
● If the rotational speed does not increase with your machine, lower the table feed rate and rotational speed at the same ratio.

Model Number
RTBEM

Model Number
ZEON3S / ZEON3L

●Feed rate of tool (mm/min) : F = f x Z x N x (d-D) / d
f : Feed per blade (mm) Z : Number of flutes (No. of grooves) N : Rotation speed (min^-1) D : Flute diameter (mm) d : Machining diameter (mm)